TOPGUARD® Fire Resistant, revolutionising fire safety
 
 

First and foremost, Topguard® Fire Resistant by Verimpex is a first-class floor mat: a top-quality, stylish and low-maintenance mat which keeps dirt where it belongs, outside.

However, Topguard® Fire Resistant is much more: this revolutionary mat is an ally to all who take fire safety in buildings seriously.
Because mats are usually placed in high-traffic areas – entrances and passageways – and these are just the places which must remain completely flame- and smokefree in the event of an evacuation. Topguard® Fire Resistant by Verimpex will do just that: this mat is fireproof, self-extinguishing, and does not generate any smoke. These unique features may well prove to be decisive in life-and-death situations.

You’d rather not play with fire? From now on, protect your buildings with Topguard® Fire Resistant by Verimpex, the only floor mat to comply with the most stringent European fire safety standard. Read all about it in this brochure.

 
 
              TOPGUARD® Fire Resistant complies with the most stringent European fire safety standard B fl s1
 
 

Topguard® Fire Resistant’s burning behaviour has been tested by the Department of Textiles at the Ghent University.       

To this end, samples were delivered to the University. The first sample was tested length- as well as widthwise; the three subsequent tests were only conducted in the direction which proved to yield the worst results (in this case, lengthwise).

The samples were attached to a fibre-cement slab. They were set aflame using a pilot burner, after which they were irradiated for 10 minutes using a gas radiator at a 30 ° angle.
With combustible materials, the test is over once there are no more flames. If after 30 minutes this is still not the case, the test is terminated.

The testing criterion in this test is the burning length: from this, the radiation intensity is deduced based on a calibration curve.
These 4 laboratory tests showed that the radiation intensity of Topguard® Fire Resistant is over 8.0 kW/m², while smoke development is lower than 750 % min. Accordingly, Topguard® Fire Resistant is compliant with the most stringent European fire safety standard, the B fl s1.

 
 
 

In conslusion, Topguard® Fire Resistant by Verimpex has 3 important advantages:
The mat is fireproof, self-extinguishing and does not generate smoke when burning.

 

  
  Radiation intensity

 
  Burn length maximum (mm) Self-extinguishing time (min.s) Radiation intensity (kW/m²)
Topguard® Fire Resistant      
Width 20 12'00" 11.4
Length of sample 1 115 12'27" 10.6
Length of sample 2 235 17'34" 8.5
Length of sample 3 275 26'44" 7.7
Average length 208    

  The above table shows that Topguard® Fire Resistant stops burning within 30 min. and that the average burn length amounts to 208 mm whereas in the case of a non-Fire Resistant mat the burn lengths amount to 650 mm.
The average radiation intensity of Topguard® Fire Resistant is 8.9kW/m².

  
  Smoke production (% min)

 
Topguard® Fire Resistant After 10 min. After 20 min. After 30 min. Maximum
Width 34 34 35 35
Length of sample 1 45 55 56 56
Length of sample 2 87 248 251 251
Length of sample 3 84 393 450 450
Average length 72 232 252 252

  As the radiation intensity exceeds 8.0kW/m² and the smoke production is lower than 750% min Topguard® Fire Resistant meets the conditions of the standard B fl s1.

 
  TEST Non-Fire Resistant TEST TOPGUARD® Fire Resistant

 
  Burn length (mm)
  Smoke production (% min)
 
 
  Non-Fire Resistant Topguard® Fire Resistant
  Non-Fire Resistant Topguard® Fire Resistant